inert filler
英 [ɪˈnɜːt ˈfɪlə(r)]
美 [ɪˈnɜːrt ˈfɪlər]
惰性填料
双语例句
- With increasing filler retention, the sheet lose strength, apparently because the inert filler reduces the number of sites for fiber-to-fiber bonding.
填料减少了纤维间结合键的数量，所以纸张失去了硬度。 - Although GF is electrically inert, its presence can increase the effective concentration of the conductive filler by holding up some space, therefore the conductivity of the material increases.
虽然GF为导电惰性填料，但因其加入起到了占位作用，明显提高了导电填料的有效浓度，从而使复合材料的体积电阻率明显降低。 - Reactive sintering of ceramics on the base of boron nitride was studied, and the inert filler was given in this paper.
研究了氮化硼陶瓷的反应烧结，给出了所用惰性填料。 - Gypsum-based building putty has changed the traditional technology mode, in which the solid component is used only as inert filler, and the stiffening of putty depends completely on film forming of the organic binder.
石膏基建筑腻子改变了传统建筑腻子中固体组分仅作为惰性填料，腻子硬化完全依赖有机粘结剂固化成膜的技术模式。 - Focused on the application of magnesium alloy welding materials, this paper researched the preparation process of Mg welding wire and explored the tungsten inert gas welding process with filler wire of magnesium alloys butted plates.
本文紧密结合镁合金焊接材料在实际焊接中的应用，研究了镁合金焊丝的制备工艺，并采用填丝TIG焊接方法，完成了镁合金板材的对接连接。 - Study on Gas-liquid Mass Transfer With Different Packing Ratios Between Catalyst and Inert Filler in Trickle Beds
滴流床中催化剂与惰性填料不同配比下的气液传质研究 - Because TIG welded joints without filler wire always hold low strength and poor formation, tungsten inert gas welding process with filler wire is inevitable.
由于镁合金不填丝的TIG焊接接头强度低，焊缝表面成型不好，所以，镁合金的填丝TIG焊接方法不可避免。